Radwin Ltd. WINLINK 사용자 설명서

Quick Start Guide 

AirMux-104 Installation and Operation Manual 

2 

Installing AirMux-104 Units 

 

 

To align the RTs: 
1.  Connect power to the RTCBs. 
2.  Turn the local RT in the direction of the remote RT. 
3.  At the remote site, align the RT to face the local RT. (Align visually or by using 

a map and a compass). Use the RSS/SNR, LINK and STATUS LEDs at the base 
of the RT for the link quality indication: 

 

RTs are not aligned: 

 

Triple RSS/SNR LED is blinking 

 

LINK LED is OFF 

 

STATUS LED is blinking slowly. 

 

RTs are aligned: 

 

Triple RSS/SNR LED is blinking or lit steadily  

 

LINK LEDs is lit steadily 

 

STATUS LED is blinking rapidly. 

4.  Repeat steps 3 to 4 for the local RT to complete the installation procedure. 
5.  Make sure that the management station is properly connected to the local 

RTCB, and the AirMux Manager application is running. 

6.  In the Main menu, click Monitor. 
7.  Verify the radio signal strength (RSS) and sound-to-noise ratio (SNR) in the 

Main menu.  

 

RSS is better than -88 dBm 

 

SNR must be at least 9 dB. 

 

 

8.  View these parameters for about 15 min. to verify stability. After achieving the 

best RSS and SNR levels, permanently attach the remote RTs to the mast/wall. 

 

 

 

 

To connect user equipment to the RTCB: 
1.  Connect user mux or PBX to the RTCB rear panel RJ-45 port designated E1. 
2.  Connect user hub/router or any other compatible device to the RTCB rear 

panel RJ-45 port designated 10/100 LAN.