Radwin Ltd. WINLINK 사용자 설명서
Appendix B Mast and Wall Installation
AirMux-104 Installation and Operation Manual
B-2
Mounting AirMux-104 on a Mast
B.2 Mounting AirMux-104 on a Mast
The kit allows you to mount the RT on masts, whose diameter is between 5 cm
(1.9 in) and 8 cm (2.3 in).
(1.9 in) and 8 cm (2.3 in).
To install the RT on the mast:
1. Insert both strap clamps through the vertical slots in the pivoting bracket. Make
1. Insert both strap clamps through the vertical slots in the pivoting bracket. Make
sure to use the slots that match the mast diameter.
2. Attach the pivoting bracket assembly to the mast using the strap clamps, but do
not completely tighten the strap clamps yet.
3. Fasten the mounting plate to the rear of the RT, using the four bolts and
locking washers. Make sure that the curved slot of the mounting plate is facing
the two-bolt side of the pivoting bracket.
the two-bolt side of the pivoting bracket.
4. Attach the RT assembly to the pivoting bracket on the mast, so that:
The two bolts on the pivoting bracket enter the hole and curved slot in the
mounting plate.
mounting plate.
The mounting plate bolt enters the hole in the pivoting bracket.
5. Attach the three hex nuts, but do not tighten them.
6. Align the RTS, as explained in
6. Align the RTS, as explained in
in Chapter 3.
7. When the alignment process is completed, permanently fasten the RT to the
mast by tightening the hex nuts and the strap clamps.
Figure B-5. RT Mounted on a Mast