Telephonics Wireless Corporation 8504HI0001000 사용자 설명서

 

The following procedures are to be used when installing the nanoCell and its associated antennas. 

There are two antennas to be installed, one for the mobile side of the nanoCell and one for the 
BTS side.  The minimum separation between the antennas is site dependant; refer to the site 
configuration sheet.  The main concern in antenna separation is to obtain 60 dB or more of 
attenuation between the nMS and nBTS antennas.  

The antennas are standard GSM antennas and are to be mounted in accordance with company 
procedures. 
 

 

Exercise caution when installing ground cable.

 

Cables are to be terminated and dressed in accordance with current company installation 
procedures.   

Grounding of the antennas is to be in accordance with company and local building codes.  A 
minimum of 6-gauge wire is to be utilized.   

The following procedures are to be followed when installing the nanoCell.  The nanoCell is 
capable of being mounted in one of three configurations:  pole mount, wall mount, or pad mount.  
This manual will address the pole mounting of the nanoCell. 

This may be done in the warehouse prior to shipment to the installation site.  The following steps 
need to be followed when initially unpacking the nanoCell.   
 

a.  Verify that there is no visible damage to the shipping container.  Make note of any 

damage prior to opening the container.  Notify the shipper if there is visible damage 
to the exterior of the container. 

b.  Verify all components listed on the parts list are present.  Record any discrepancies. 

c.  Inspect the nanoCell for any signs of damage that may have occurred during transit. 

d.  If there is any damage to the nanoCell contact the shipper and then notify 

Telephonics at (321)-757-6336. 

 

10