Telephonics Wireless Corporation 8504HI0001000 사용자 설명서
visual indicators on the unit. Only non-field service would require the unit to be opened for
observation of the LEDs.
After POST successfully completes, the nanoCell’s application program will examine the system
configuration database and complete its hardware and software compatibility checks. If there is a
detected incompatibility or the minimum required data is not present, the nanoCell will wait in a
non-operational mode for data input via the command line interface or remote program load using
BOOTP protocol. Lack of data would indicate that the nanoCell has not been. The nanoCell will
not progress any further until properly programmed and reset.
A connection to the LMT permits the download of additional control parameters and/or
application software as necessary, as well as uploading nanoCell status and event data. The
nanoCell can be commanded to enter the Maintenance mode at any time by the LMT.
Application software may be downloaded via the command line interface while the nanoCell is in
this mode. When valid application software is present, the nanoCell will proceed to execute the
application.
observation of the LEDs.
After POST successfully completes, the nanoCell’s application program will examine the system
configuration database and complete its hardware and software compatibility checks. If there is a
detected incompatibility or the minimum required data is not present, the nanoCell will wait in a
non-operational mode for data input via the command line interface or remote program load using
BOOTP protocol. Lack of data would indicate that the nanoCell has not been. The nanoCell will
not progress any further until properly programmed and reset.
A connection to the LMT permits the download of additional control parameters and/or
application software as necessary, as well as uploading nanoCell status and event data. The
nanoCell can be commanded to enter the Maintenance mode at any time by the LMT.
Application software may be downloaded via the command line interface while the nanoCell is in
this mode. When valid application software is present, the nanoCell will proceed to execute the
application.
4.3 System
Provisioning
The nanoCell is provisioned using the Local Maintenance Terminal software. The information
necessary for input will be contained in the site reference document.
There are two areas that will be addressed during the provisioning process; System Parameters
and Licensing.
necessary for input will be contained in the site reference document.
There are two areas that will be addressed during the provisioning process; System Parameters
and Licensing.
Tools needed for provisioning
a.
b.
a.
b.
c.
d.
Laptop with LMT software
CAT-5 Ethernet cable
Installation instructions
Power on the laptop and connect the Ethernet cable to the Ethernet port located inside
the right access panel. (As viewed from the front of the nanoCell).
the right access panel. (As viewed from the front of the nanoCell).
Verify that power has been applied to the nanoCell for at least 5 minutes to allow
time for the nanoCell boot process to complete.
time for the nanoCell boot process to complete.
Once the laptop has booted and power applied to the nanoCell, double-click the LMT
icon located on the desktop of the laptop.
icon located on the desktop of the laptop.
The LMT software will launch and will display the screen as shown in Figure 9.
Telephonics Wireless Corporation, Proprietary and Confidential
Copyright © 2002,2003 Telephonics Wireless Corporation. All rights reserved
16