Mobilicom ltd. MCU-30L 사용자 설명서
MCU-30 User Manual
Page : 20 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
6.1.3 RF Characteristics
• Max output power: 2 x 0.5W per channel
• Average output power :2x 200mW per channel (23dBm)
• Noise Figure: 5dBm
• Transmission Power Control Range: 50dB in 1dB steps.
• Radio Access Method: OFDM - TDMA
• Configuration & Diversity Support: 2X2 MIMO with MRC(RX) and CDD(TX)
• Frequency Resolution: 0.25MHz
• Channel bandwidth: Configurable 4.2/8.4MHz
• FFT Supported: 512
• Guard band: 64 sub-carries each side
• Total subcarriers used per symbol: 384
• Data carriers used: 336
• Pilot carriers used: 48
• Sub carrier spacing: 13KHz for 5MHz bandwidth with 5msec frame
• Modulations: QPSK
• FEC methods: CTC
• FEC Ratios ¾ , ½ , ¼
• Error Detection: CRC32
• Full TDD asymmetrical duplexing
• Average output power :2x 200mW per channel (23dBm)
• Noise Figure: 5dBm
• Transmission Power Control Range: 50dB in 1dB steps.
• Radio Access Method: OFDM - TDMA
• Configuration & Diversity Support: 2X2 MIMO with MRC(RX) and CDD(TX)
• Frequency Resolution: 0.25MHz
• Channel bandwidth: Configurable 4.2/8.4MHz
• FFT Supported: 512
• Guard band: 64 sub-carries each side
• Total subcarriers used per symbol: 384
• Data carriers used: 336
• Pilot carriers used: 48
• Sub carrier spacing: 13KHz for 5MHz bandwidth with 5msec frame
• Modulations: QPSK
• FEC methods: CTC
• FEC Ratios ¾ , ½ , ¼
• Error Detection: CRC32
• Full TDD asymmetrical duplexing
Flexible ratio from 1:1 to 1:9 in Mobile PTP
Resolution of 1% between all units in Mobile MESH and Collaborative MESH
networks
NOTE – The wide configurable power control range enables transmitting in low
TX power when not needed and by that reducing the power consumption.
TX power when not needed and by that reducing the power consumption.