Hewlett Packard Enterprise Company MSR4000DFS 사용자 설명서

| Installation Guide

1. Cut a 4” (100 mm) strip of electrical tape from the roll.

2. Where you begin wrapping depends on the orientation of the antenna. Water should flow in the opposite 

direction of the wrapping to prevent water from entering the connector between the layers of tape.

Therefore, if the antenna is facing up, you should begin wrapping at the router end of the connector. This 
will ensure that your fourth and final layer will be layered correctly. Conversely, if your antenna is facing 
down, you should begin wrapping on the antenna end of the connector. 

3. After completing the fourth layer of tape, check your work to ensure there are no places where water 

can collect. If there are, you must smooth out those areas with additional layers of tape or remove the 
weatherproofing and begin again. 

Figure 13  Completed Wrapping (Antenna on Top of router)

4. Repeat this process for all connectors.

First and third layers wrap

top to bottom

Rubber will

be wrapped

with 4 layers

of tape

Second and final layers wrap

bottom to top

Pieces of tape as needed