Controlled Electronic Management Systems Ltd INFOPROX 사용자 설명서
Configuring the Door Control Unit
InfoProx Entry
Configure Time Zone
The time zone configuration screen appears automatically after the Config Time
screen.
screen.
Configuring the time zone
Config Tz Start
0-Yes, Other-No
0-Yes, Other-No
1.
Press 0 to setup Start Time.
The following prompt appears:
TZone Off HH:MM
New TZone 00:00
New TZone 00:00
2.
Enter a four-digit value equivalent to the hour and minute to start
Timezone (i.e. 08:30). The span of the time zone is defined by first
entering the start time (Config TZone Start) and the end time (Config
TZone End) of the time zone.
Timezone (i.e. 08:30). The span of the time zone is defined by first
entering the start time (Config TZone Start) and the end time (Config
TZone End) of the time zone.
As you enter the last digit, the following prompt appears
TZone=08:30
Ù
to accept
3.
Press
Ù to accept the entered Timezone.
The prompt changes to:
Config TZone End
0-Yes, Other-No
0-Yes, Other-No
4.
Press 0 to setup an End Time.
The prompt changes to:
TZone End HH:MM
New TZone 00:00
New TZone 00:00
5.
Enter a four-digit value equivalent to the hour and minute when
Timezone is to end (i.e. 17:00).
Timezone is to end (i.e. 17:00).
After you enter the last digit, the display changes to:
TZ=17:00
Ù
to accept
6.
Press
Ù to accept the displayed Timezone.
Note
As each value is entered, the reader verifies that the value is
valid.
valid.
After pressing
Ù, accepting the TZ End Time, the prompt appears
Config TZ Type
30
Software
House