ADview Technology Co. Ltd. IL-1900AV 사용자 설명서

다운로드
페이지 25
INTRODUCTION
INTRODUCTION
FCC COMPLIANCE STATEMENT
Note:
This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a 
Class  B  digital  device,  pursuant  to  Part  15  of  FCC  Rules.  These  limits 
are  designed  to  provide  reasonable  protection  against  radio  frequency 
interference  in  a  residential  installation.  This  equipment  generates,  uses 
and  can  radiate  radio  frequency  energy.  If  not  installed  and  used  in
accordance  with  the  instructions,  it  may  cause  interference  to  radio
communications.  However,  there  is  no  guarantee  that  interference  will 
not  occur  in  a  particular  installation.  If  this  equipment  does  cause
interference  to  radio  or  television  reception  (this  can  be  determined  by
turning  this  equipment  off  and  on),  the  user  is  encouraged  to  try  to 
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
CAUTION TO THE USER:
The  Federal  Communications  Commission  warns  that  changes  or
modifications  to  the  unit  not  expressly  approved  by  the  party  responsible 
for compliance could void the user's authority to operate the equipment.
If necessary, the user should contact the dealer or an experienced 
radio/television  technician  for  additional  suggestions.  The  user  may  find 
the  Federal  Communications  Commission  booklet,  How  to  Identify  and
Resolve  Radio-TV  Interference  Problems, helpful.  This  booklet  is
available from the U.S. Government Printing Office, Washington, D.C.,
Stock No. 004-000-00345-4.
NOTICE OF COMPLIANCE WITH CANADIAN
INTERFERENCE-CAUSING EQUIPMENT
REGULATIONS
i