AirVast Technology Inc. WN500 사용자 설명서

 

 

- 2 - 

 

STATEMENT FOR MODUAL APPROVAL 

 
This product is sold to OEM integrators only. The manual for the OEM integrators 
must include some instructions to be followed by the end users in the user manual. 
For example: 
 
- The OEM integrators must be instructed to ensure that the end user has  no 
manual instructions to remove or install the device. 
- The OEM integrators must be instructed about the end product labeling 
("Contains TX FCC ID: QDWWN500"). 
 
This device is intended only for OEM integrators under the following conditions: 
1) The antenna must be installed such that 20 cm is maintained between the 
antenna and users, and 
2) The transmitter module may not be co-located with any other transmitter or 
antenna. 
 
As long as the 2 conditions above are met, further transmitter test will not be 
required. However, the OEM integrator is still responsible for testing their end 
product for any additional compliance requirements required with this module 
installed (for example, digital device emissions, PC peripheral requirements, etc.). 
 
IMPORTANT NOTE: In the event that these conditions cannot be met (for example 
certain laptop configurations or co-location with another transmitter), then the FCC 
authorization is no longer considered valid and the FCC ID cannot be used on the 
final product. In these circumstances, the OEM integrator will be responsible for 
re-evaluating the end product (including the transmitter) and obtaining a separate 
FCC authorization. 
 
End Product Labeling 
This transmitter module is authorized only for use in device where the antenna 
may be installed such that 20 cm may be maintained between the antenna and 
users (for example, access points, routers, wireless ADSL modems, and similar 
equipment). The final end product must be labeled in a visible area with the 
following: "Contains TX FCC ID: QDWWN500". 
 
Manual Information for End Users 
The end user must not have manual instructions to remove or install the device. 
The user manual for end users must include the following information in a 
prominent location. 
This device cannot be used with handheld PDAs (personal digital assistants) or 
portable

1

 radio equipment.