Palmnet System Co. Ltd. PNS-816D 사용자 설명서
PNS-816D User’s Manual Draft 6/27/02
Palmnet System
15
3.3 ZIF 30 Pin connector Assignment
No Signal Description
No Signal Description
1 DCD
Data Carrier Detect
16 SS0
Status Input0
2 TXD
Receive Data
17 SS1
Status Input1
3 RXD
Transmit Data
18 SS2
Status Input2
4 DTR
Data Transmit Ready
19 SS3
Status Input3
5 GRD
Ground
20 VEE
3.9V
6 DSR
Data Set Ready
21 VEE
3.9V
7 RTS
Request to Sand
22 VEE
3.9V
8 CTS
Clear to Send
23 VEE
3.9V
9 RI
Ring Indicator
24 VEE
3.9V
10 /RESET
Modem Reset
25 GRD
Ground
11 S_BACKUP
3.3V Sram Backup
26 GRD
Ground
12
RPM_PWR_ON_OFF
Modem Power on/off
27 GRD
Ground
13 MSG_WAIT
Message Waiting
28 GRD
Ground
14 IN_RANGE
In Range
29 N.C.
Not used
15 LOW_BATT
Low Battery
30 N.C.
Not used
3.4 Power Supply
• Power Supply: 5V + 10%, more than 3A
• Tx Current usage: 2A
• Rx Current usage: 80mA
• Stand-by: 12mA
3.5 Notice to Integrators
Warning: Output is specified at the antenna terminal of this module. This modular transmitter is only
approved for OEM integration into final products that satisfy mobile operating requirements of 2.1091. The
final product and its antenna must operate with a minimum separation distance of 25 cm or more from all
persons using the antenna with the gain not exceeding 3 dBi to satisfy MPE compliance.
Separate approval is required for this module to operate in portable products with respect to 2.1093 of
FCC rules.
approved for OEM integration into final products that satisfy mobile operating requirements of 2.1091. The
final product and its antenna must operate with a minimum separation distance of 25 cm or more from all
persons using the antenna with the gain not exceeding 3 dBi to satisfy MPE compliance.
Separate approval is required for this module to operate in portable products with respect to 2.1093 of
FCC rules.