Cascade Networks Inc. 5200UNII 사용자 설명서

SM User Manual Draft for Regulatory Review

Page 12 of 33

module should  be mounted to the reflector in the following manner.  The reflector arm is molded to
receive the plastic housing of the subscriber module.  Use stainless steel hose clamps to secure
the module to the arm.  The module is now properly aligned within the reflector.

 

When power is applied to a Canopy module or the unit reset via the web-based interface, the
module will take approximately 25 seconds to boot up.  During this boot up time, power on self-
tests and other diagnostics are being performed.

The following steps must be performed for successful installation:

•  Select a mounting location that is free from objects, such as buildings, large trees, etc., that

will interfere with the line of sight to the Access Point cluster location.  Be mindful of the
Fresnel Zone.

•  The Canopy module should be mounted vertically as shown in FIGURE 3.  All Canopy

modules’ antennas are vertically polarized in this direction.

•  Mount the Canopy subscriber module to a secured location on the side/roof of the building.

The mount must be rigid and the subscriber module must not sway from outside forces.

•  Illustrated in FIGURE 3

 

is an example of mounting the unit to an antenna mast.  Stainless

steel hose-clamps, or any suitable outdoor equivalent, may be used to secure the unit to
the mast.