Extreme networks OAP36C 사용자 설명서
WS-AP3660 Installation Procedures
Installation
Enterasys Wireless Outdoor WS-AP3660 Installation Guide
2-3
–
WS-AIO-2S18018 — Indoor/Outdoor, 2.3 - 2.5GHz, 18dBi, 18 deg, Panel
–
WS-AO-DS05360 — Outdoor, 2.4 - 2.5/5.15 to 5.875GHz, 5dBI, Omni, Baton
–
WS-AO-5S10360 — Outdoor, 5GHz, 10dBi, Omni, Baton (FCC Domain only)
–
WS-AO-DT05120-1 — Outdoor, 2.3 - 2.7/4.9 - 6.1GHz, Triple-feed, 5dBI, 120 deg, Sector
–
WS-ANT21 — Outdoor, 2.3 - 2.4/5.1 - 5.8GHz, Omni, Baton
–
WS-AO-DX13025 — Outdoor, 2.4 - 2.5/5.1- 5.9 GHz, Six-feed, 12.5/11.5dBI, 27/30 deg,
Panel
Panel
” on page B-10 and the Enterasys Wireless
AP External Antenna Site Preparation and Installation Guide for more information about these
antennas. This document is available at:
antennas. This document is available at:
•
Power Supply. The following power supply is required for use with the WS-AP3660:
–
WS-PS3660-MR
•
Power over Ethernet (PoE) Injector. The following 802.3at PoE injector is recommended for use
with the WS-AP3660:
with the WS-AP3660:
–
PD-9001GR-ENT (this is an indoor PoE injector)
•
Terminator cap. This part is listed as a spare item as the WS-AP3660 is shipped with six
terminator caps. If you are not attaching six antennas to the WS-AP3660, you must use a
terminator cap on the antenna connector not being used.
terminator caps. If you are not attaching six antennas to the WS-AP3660, you must use a
terminator cap on the antenna connector not being used.
–
WS-CAB-RPNTERM — Terminator, Reverse Polarity, Type-N Plug, 50 OHM, 1W
•
Cables to connect the lightning protectors on the enclosure to the antennas. All cables listed
below have Reverse Polarity Type-N plugs at both ends.
below have Reverse Polarity Type-N plugs at both ends.
–
WS-CAB-L200C20 (RBTES-L200-C20F) — 20 foot LMR200 cable
–
WS-CAB-L400C06F (RBTES-L400-C06F) — 6 foot LMR400 cable
–
WS-CAB-L400C50F (RBTES-L400-C50F) — 50 foot LMR400 cable
–
WS-CAB-L400C75F (RBTES-L400-C75F) — 75 foot LMR400 cable
–
WS-CAB-L600C25F (RBTES-L600-C25F) — 25 foot LMR600 cable
–
WS-CAB-L600C50F (RBTES-L600-C50F) — 50 foot LMR600 cable
WS-AP3660 Installation Procedures
These procedures describes how to attach the mounting bracket to the WS-AP3660, how to mount
the WS-AP3660 outside (either a wall or pole), and how to attach the relevant cables.
the WS-AP3660 outside (either a wall or pole), and how to attach the relevant cables.
Note: New cable part numbers are listed first. Previous equivalent cable part numbers follow in
parentheses.
parentheses.
Electrical Hazard: This product should be installed and serviced by a qualified licensed technician,
electrician, or electrical maintenance person familiar with its operation and the hazards involved.
electrician, or electrical maintenance person familiar with its operation and the hazards involved.