D-Link Corporation IR627A1 사용자 설명서

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 

Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful 

interference in a residential installation.    This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 

radio communications.  However, there is no guarantee that interference will not occur in a particular 

installation.    If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 

one of the following measures: 

- 

Reorient or relocate the receiving antenna. 

- 

Increase the separation between the equipment and receiver. 

- 

Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 

- 

Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user's authority to operate this equipment. 

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with minimum distance 20cm between the radiator & your body. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

 

The availability of some specific channels and/or operational frequency bands are country dependent and are 

firmware programmed at the factory to match the intended destination. The firmware setting is not accessible 

by the end user. 

 

以下警語適用台灣地區 

 

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原

設計之特性及功能。

 

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干

擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工

業、科學及醫療用電波輻射性電機設備之干擾。