Hunter Industries Inc SSW 사용자 설명서
13
addressinG Wireless reCeiver/sensor
The.Wireless.Solar.Sync.Receiver.
and.Sensor.are.already.paired.with.
the.same.frequency.for.an.easy.
installation..When.installed,.the.
wireless.Receiver.will.automatically.
go.into.a.“search”.mode.looking.
for.the.signal.from.its.paired.Sensor..
However,.it.is.a.good.idea.to.initialize.
communication.manually.between.
the.wireless.Receiver.and.Sensor.
during.installation.to.verify.correct.
signal.transmission.
To initialize communication manually between wireless receiver
and Sensor:
•. .After.Receiver’s.green.and.black.wires.have.been.connected.
To initialize communication manually between wireless receiver
and Sensor:
•. .After.Receiver’s.green.and.black.wires.have.been.connected.
(see.“Connecting.To.The.Controller”.section),.restore.power..
to.the.controller
•. .The.red.LED.in.the.center.of.the.wireless.Receiver.will.turn.
on.and.stay.solid.for.10.seconds,.indicating.that.it.is.in.search.
mode,.searching.for.a.signal.from.a.wireless.sensor
•. .While.the.red.LED.is.solid.and.the.wireless.Receiver.is.in.search.
mode,.press.and.hold.the.spindle.on.the.wireless.Sensor..The.
LED.on.the.wireless.Receiver.will.blink.4.times.and.then.turn..
off,.indicating.that.the.signal.from.the.wireless.Sensor.has..
been.acknowledged..
To validate receiver/Sensor Communication or re-address:
•. Press.and.hold.the.spindle.on.the.wireless.Sensor
•. .The.LED.on.the.wireless.Receiver.will.blink.2.times,.confirming.
•. Press.and.hold.the.spindle.on.the.wireless.Sensor
•. .The.LED.on.the.wireless.Receiver.will.blink.2.times,.confirming.
that.the.Receiver.is.addressed.to.the.Sensor.properly
note: In the event of a power outage (or any other
reason when the receiver loses radio contact with
the wireless Sensor) the receiver will automatically
go into search mode to re-establish communication
with the Sensor once power is restored. However,
when power is restored the controller will automati-
cally go into rain shut off mode until communication
with the sensor is re-established, which may be up
to 60 minutes (maximum). Performing the steps listed
above to validate receiver/Sensor communication will
remove the controller from rain shut off mode and
will return to its programmed irrigation schedule.
reason when the receiver loses radio contact with
the wireless Sensor) the receiver will automatically
go into search mode to re-establish communication
with the Sensor once power is restored. However,
when power is restored the controller will automati-
cally go into rain shut off mode until communication
with the sensor is re-established, which may be up
to 60 minutes (maximum). Performing the steps listed
above to validate receiver/Sensor communication will
remove the controller from rain shut off mode and
will return to its programmed irrigation schedule.
led
spindle