Netronix Inc W423B 사용자 설명서
22
Items
Information
Use Client certificate
Client certificate for server authentication.
WPS AP List
Display the information of surrounding APs with WPS IE from last
scan result. List information includes SSID, BSSID, Channel, ID
(Device Password ID), and Security-Enabled.
(Device Password ID), and Security-Enabled.
Rescan
Click to rescan the wireless networks.
Information
Display the information about WPS IE on the selected network. List
information include Authentication Type, Encryption Type, Config
information include Authentication Type, Encryption Type, Config
Methods, Device Password ID, Selected Registrar, State, Version, AP
Setup Locked, UUID-E and RF Bands.
Setup Locked, UUID-E and RF Bands.
PIN Code
8-digit numbers. It is required to enter PIN Code into Registrar using
PIN method. Each Network card has only one PIN Code of Enrollee.
Config Mode
Enrollee or an external Registrar.
Table of Credentials
Display all of credentials got from the Registrar. List information
includes SSID, MAC Address, Authentication and Encryption Type. If
includes SSID, MAC Address, Authentication and Encryption Type. If
STA Enrollee, credentials are created as soon as each WPS success.
If STA Registrar, Utility creates a new credential with
If STA Registrar, Utility creates a new credential with
WPA2-PSK/AES/64Hex-Key and doesn't change until next switching
to STA Registrar.
to STA Registrar.
Detail
Information about Security and Key in the credential.
Connect
Command to connect to the selected network inside credentials.
Rotate
Command to connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select the
last profile at the Profile Page of Utility if exist. If there is an empty
profile page, the driver will select any non-security AP.
last profile at the Profile Page of Utility if exist. If there is an empty
profile page, the driver will select any non-security AP.
Delete
Delete an existing credential. And then select the next credential if
exist. If there is an empty credential, the driver will select any
non-security AP.
exist. If there is an empty credential, the driver will select any
non-security AP.
PIN
Start to add to Registrar using PIN configuration method.
PBC
Start to add to AP using PBC configuration method.
WPS associate IE
Send the association request with WPS IE during WPS setup. It is
optional for STA.
WPS probe IE
Send the probe request with WPS IE during WPS setup. It is optional
for STA.
for STA.
Progress Bar
Display rate of progress from Start to Connected status.
Status Bar
Display currently WPS Status.
Note:
When you click PIN or PBC, please don't do any rescan within two-minute connection. If
you want to abort this setup within the interval, restart PIN/PBC or click Disconnect to stop WPS
action.
action.