Humax T9 사용자 설명서
DUT Graphical User Interface
DUT Tool Package
Using the DUT GUI
Confidential
User’s Guide
23
Revision 1.1, 2013-05-06
5.11
DUT and Chip Versions
Figure 18
Version Information
During startup, the DUT GUI reads the RF and BB chip versions from the relevant HW registers in the chips and
displays it together with the DUT GUI application version.
The RF chip version 0x30 indicates XWAY™ WAVE300 (PSB 8301, PSB 8304) RFIC
The BB chip version 0x710 indicates XWAY™ WAVE300 (PSB 8221, PSB 8231) BBIC
displays it together with the DUT GUI application version.
The RF chip version 0x30 indicates XWAY™ WAVE300 (PSB 8301, PSB 8304) RFIC
The BB chip version 0x710 indicates XWAY™ WAVE300 (PSB 8221, PSB 8231) BBIC
5.12
Reading and Writing the EEPROM/Flash
5.12.1
Configuring EEPROM/Flash Area Size
EEPROM/Flash area size may be configured via dut_cfg.txt file.
It is possible to specify EEPROM/Flash area size in bytes by the means of parameter EEPROM_Size_Bytes. The
default value is 1024 bytes.
It is possible to specify EEPROM/Flash area size in bytes by the means of parameter EEPROM_Size_Bytes. The
default value is 1024 bytes.
5.12.2
Burning a File to EEPROM/Flash
Figure 19
EEPROM/Flash Burning Section
The EEPROM/Flash contains important information for operation of the module. The information includes:
•
•
PCI information (including Vendor ID and Device ID).
•
HW Type and HW version information - To determine which firmware to load to the module.
•
TPC calibration information.
Attention: A module will not work without correct values in the EEPROM/Flash for all three areas
mentioned above.
The EEPROM/Flash is usually burned only once, during the production testing. Information burned into the
EEPROM/Flash consists of a text file in the following form:
EEPROM/Flash consists of a text file in the following form:
<Address><data>