Humax T9 사용자 설명서
DUT Graphical User Interface
DUT Tool Package
Appendix A - PCI EEPROM Address Map
Confidential
User’s Guide
33
Revision 1.1, 2013-05-06
7
Appendix A - PCI EEPROM Address Map
The eeprom structure includes four major sections:
1. Executive control Region (00-04h)
1. Executive control Region (00-04h)
The first two words are the eeprom signature. The signature is a known number which indicates valid eeprom
information (e.g. not empty).
information (e.g. not empty).
2. PCI spec RunTime registers (05-0Bh)
These registers are the PCI configuration registers which must be in any PCI device. These registers with
combination of the CIS (see section 4), define the HW installed at the PCI bus. This region is restricted for PCI
HW definition native needs.
combination of the CIS (see section 4), define the HW installed at the PCI bus. This region is restricted for PCI
HW definition native needs.
3. RunTime registers - (0C-3Fh)
These registers are used as default configuration for the PCI
Initiator and target HW. It includes Device and Vendor Id, shared RAM address and configuration space
address.
address.
4. Initialization section - (40-F8h)
This section is used to save initialization parameters as Card type and version, MAC address, serial number,
calibration data and other Metlalink's native information.
calibration data and other Metlalink's native information.
Data
Address
Header
0x40-0x47
HW configuration Sub Section type
0x48
HW configuration Sub Section length
0x49
HW type
0x4A
HW revision
0x4B
Country code (for Regulation domain) See APPENDIX F
for full country code list
for full country code list
0x4C
BB chip ID
0x4D
RF chip ID
0x4E
MAC address
0x4F-0x54
Serial number
0x55-0x57
Week and Year
0x58-0x59
TPC Calibration data Sub Section type
0x5A
TPC Calibration data Sub Section length
0x5B
TPC Calibration data
0x5C - 0xF8
Note: Modification of all sections off the EEPROM is forbidden and could result in initialization failure.
Table 7
EEPROM Address Map