Symbol Technologies LA-5030 사용자 설명서
Customer Support
66
Wireless Networker LA-5030 PC Card & LA-5033 PCI Adapter User Guide
This device is intended only for OEM integrators under the following
conditions:
1) The antenna should be integral if the end device is intended to be
conditions:
1) The antenna should be integral if the end device is intended to be
operated in 5.15 ~ 5.25GHz frequency range.
As long as 1 condition above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met
(for example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met
(for example certain laptop configurations or co-location with another
transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
“Contains TX FCC ID:
H9PLA5030”.
Manual Information That Must be Included
The OEM integrator has to be aware not to prov ide information to the end
user regarding how to install or remove this RF module in the users
manual of the end product which integrate this module.
The users manual for OEM integrators end users must include the
following information in a prominent location “ IMPORTANT NOTE: To
comply with FCC RF exposure compliance requirements. The antenna
must not be co-located or operating in conjunction with any other antenna
or transmitter”.
If the end product integrating this module is going to be operated in 5.15 ~
5.25GHz frequency range, the warning statement in the user manual of
the end product should include the restriction of operating this device in
indoor could void the user’s authority to operate the equipment.
user regarding how to install or remove this RF module in the users
manual of the end product which integrate this module.
The users manual for OEM integrators end users must include the
following information in a prominent location “ IMPORTANT NOTE: To
comply with FCC RF exposure compliance requirements. The antenna
must not be co-located or operating in conjunction with any other antenna
or transmitter”.
If the end product integrating this module is going to be operated in 5.15 ~
5.25GHz frequency range, the warning statement in the user manual of
the end product should include the restriction of operating this device in
indoor could void the user’s authority to operate the equipment.
Symbol declared that LA-5030 is limited in CH1-CH11 by specified firmware
controlled in USA.
controlled in USA.