Honeywell International Inc. THM5421R02 사용자 설명서
2
Prestige/VisionPRO with RedLINK: Mount the thermostat and wire to C and
R terminals of the Equipment Interface Module (EIM), or to a separate 24 volt
transformer (not provided).
R terminals of the Equipment Interface Module (EIM), or to a separate 24 volt
transformer (not provided).
NOTE:
When the VisionPRO with RedLINK thermostat is used with the EIM, the
relays in the thermostat do not function.
R
Y2
G
W
O/B
W2
AUX1
W3
AUX2
A L/A
Strip 1/4”
insulation,
then insert
wires as
shown.
Use screws & anchors as appropriate for the mounting surface. Mount the EIM near
the HVAC equipment, or on the equipment itself.
the HVAC equipment, or on the equipment itself.
CONNECT
C N ECT D
NOTE:
If you install more than one thermostat
and EIM, the EIMs must be at least 2 feet
apart.
apart.
NOTE:
If you are installing discharge and
return air sensors, refer to the mounting
instructions in the Alerts and Delta T
Diagnostics Installation Instructions packed
with the Prestige IAQ kit.
instructions in the Alerts and Delta T
Diagnostics Installation Instructions packed
with the Prestige IAQ kit.
If an EIM is mounted inside a metal cabinet, it is
recommended to use a THM4000R1000 Wireless
Adapter for extended wireless range. Mount the
Wireless Adapter outside the metal cabinet and
connect to the ABCD terminals at the EIM.
recommended to use a THM4000R1000 Wireless
Adapter for extended wireless range. Mount the
Wireless Adapter outside the metal cabinet and
connect to the ABCD terminals at the EIM.
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
1
2
Install thermostat
Install equipment interface module
EIM
A
B
B
C
D
D
WIRELESS
ADAPTER
CONNECT
POWER
THM4000R
CONN CTED
W RELESS SETUP