Murata Electronics North America DNT24 사용자 설명서
www.Murata.com
Technical support +1.678.684.2000
Page 61 of 83
© 2015 by Murata Manufacturing Co. Ltd.
E-mail:
tech_sup@murata.com
DNT24 Integration Guide – 03/04/15
8.4 Developer’s Kit Hardware Assembly
1. Figure 8.4.1 shows a DNT24P radio installed on an interface board, and a patch antenna. Observe
ESD precautions when handling the kit circuit boards. Install a patch antenna on each interface board by
pressing the antenna into the interface board RF connector with moderate pressure until the antenna
snaps onto the connector, as shown in Figure 8.4.2. Note that no external antenna is required when using
the DNT24PA radios supplied in the DNT24A Kits.
ESD precautions when handling the kit circuit boards. Install a patch antenna on each interface board by
pressing the antenna into the interface board RF connector with moderate pressure until the antenna
snaps onto the connector, as shown in Figure 8.4.2. Note that no external antenna is required when using
the DNT24PA radios supplied in the DNT24A Kits.
2. As shown in Figure 8.4.3, there are three serial connectors and a power connector on the end of each
interface board. The RJ-45 connector provides an RS232 interface to the DNT24 main serial port. The
USB connector provides an optional interface to the radio’s main serial port.
interface board. The RJ-45 connector provides an RS232 interface to the DNT24 main serial port. The
USB connector provides an optional interface to the radio’s main serial port.
Figure 8.4.1
Figure 8.4.2
Figure 8.4.3
3. If using a serial cable, connect the Base interface board to the PC using a RJ-45/DB-9F cable assem-
bly (labels on the bottom of the interface boards specify Base or Remote). Then power the Base with a
supplied wall-plug power supply. Continue at Step 5 below.
bly (labels on the bottom of the interface boards specify Base or Remote). Then power the Base with a
supplied wall-plug power supply. Continue at Step 5 below.