Wacom DTF-521 사용자 설명서

 24  

 

When multiple interactive pen tablets are connected and are to be used, it is necessary to set up the 

pen and calibrate for each interactive pen tablet individually. Please follow the procedures below to 

carry this out.

1

Bring the pen tip near the display of  the tablet for which the setup is to take place. Verify that the 

pointer moves in conjunction with the pen tip.

2

Open the control panel. (Please refer to the screen picture accompanying Step 1 of  the procedure de-

scribed in “Protrusion of  the Picture from the LCD Panel and the Blurring of  Characters...” on page 

15.)

3

Open the Calibrate tab and verify that the correct monitor name is displayed in the Monitor field.

● If Another Monitor Name is Displayed in the Monitor Field...

  The control panel of  a different interactive pen tablet is being displayed. Press the ESC key on  

  the keyboard to delete the control panel and, beginning with Step 1, repeat the above procedure  

  to display the correct control panel.

*If the monitor name is changed without displaying the control panel, the tablet will not be able to be set 
up.

 【Important】

 

  Example ＞ Setting up Tablet A when Tablet A and Tablet B are connected.

  1. The pointer is identified by Tablet A.

  2. The control panel of Tablet A is displayed. → OK

    The pen is used on Tablet B to display the control panel → NOT OK (This carries out the  

    setup of Tablet B)

    The computer mouse is used on Tablet B to display the control panel → OK

4

Refer to  Protrusion of the Picture from the LCD Panel and the Blurring of Characters...  on 

page 15 and carry out calibrations. 

To set up the pen, open the PEN tab, refer to “Switch and Button Settings” on page 22 and carry 
out the setup.

5

Repeat Steps 1 ‒ 4 to set up another tablet.