Wacom DTU-2231 사용자 설명서

99-00724-00 REV C0

CHAPTER 2 – INSTALLING THE SMART INTERACTIVE PEN DISPLAY

Matching the Resolution

Before the image output of the computer can display properly on the interactive 
screen, you must set the computer’s resolution to the screen’s native resolution.

Set the resolution of the computer to 1920 × 1080 pixels (full HD) and set the refresh 
rate to between 56 Hz and 76 Hz.

If you need to change the display settings on the computer, you must use the mouse.

NOTES
–

Depending on your version of the Windows operating system, the dialog box 
labels may vary slightly. The basic procedure is described below, but the 
specific steps vary between operating systems.

–

Some Mac computers transmit video signals outside the 56 Hz–76 Hz 
synchronization range. These models cannot be used with the Sympodium 
interactive pen display.

1. Open the Windows Control Panel.

2. Click Display.

3. The Display Properties dialog box appears.

4. Click the Settings tab.

5. Move the slider to change the screen resolution to 1920 × 1080.

6. Click OK.

1. Click the System Preferences icon in the Dock.

2. Click Displays.

3. On the Display tab, select 1920 × 1080. 

NOTE
Don’t set the Refresh Rate to higher than 76 Hz.

4. Close the dialog box.