Denso Corporation BTAU01A 사용자 설명서

 
6.2.User’s Manual Requirement of FCC rule 
 
BTAU01A and BTAU02A are installed in vehicle’s Audio System, so BTAU01A and BTAU02A has no 
manual for user. 
FCC user’s manual requirements that are FCC rule Part 15.21 and 15.105 are described on user’s 
manual of the vehicle as followings. 
 

FCC and RSS-210 Regulations 

 
This device complies with Part 15 of the FCC Rules and RSS-210 Rules. 
Operation is subject to the following two conditions : 
(1)  this device may not cause harmful interference, and 
(2)  this device must accept any interference received, including interference that may cause undesired 

operation. 

 
FCC WARNING: Changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment. 
 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules.  These limits are designed to provide reasonable protection 
against harmful interference in a residential installation.  This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications.    However, there is no guarantee that interference 
will not occur in a particular installation.    If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different form that to which the receiver is connected. 
-Consult the dealer or an experienced radio/TV technician for help. 
 
CAUTION : Radio Frequency Radiation Exposure 
This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and 
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment 
has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio 
(SAR). 

 

Co-location : This transmitter must not be co-located or operated in conjunction with any other antenna 
or transmitter.