Zebra Technologies Corporation RFID-Z4M-01 사용자 설명서

34

 

R4Mplus User Guide

Load Fanfold Media

Fanfold media feeds through either the bottom or rear access slot. See 

.

1. Press the printhead open lever. The printhead assembly springs up.

2. Flip down the media supply guide.
3. Slide the media guide as far from the main frame as possible.
4. Pass the fanfold media over the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide until it just touches, but 

does not restrict, the edge of the media.

6. Thread the media under the dancer, through the slot in the transmissive sensor, under the 

ribbon sensor, and out the front of the printer.

7. Ensure the media is against the back of the transmissive sensor. Then, slide in the media 

guide until it just touches, but does not restrict, the edge of the media.

8. Close the printhead assembly.
9. Press 

.

Caution • Ensure that the printhead is fully open and engaged in the upright 
position. If you fail to latch the printhead, it could fall on your hand during the 
procedure.