Zebra Technologies Corporation RFID-Z4M-01 사용자 설명서
42
R4Mplus User Guide
Printer Operation
Install Memory Card
Install Memory Card
The printer can use Type I or Type II compliant PCMCIA memory cards.
To install the PCMCIA memory card, complete these steps:
1. Remove the PCMCIA card shield from the rear of the printer.
2. Insert the PCMCIA card, with the notch UP, into the card slot as shown (see
2. Insert the PCMCIA card, with the notch UP, into the card slot as shown (see
Figure 26
).
Insert the card far enough to cause the eject button to pop out.
3. Reinstall the PCMCIA card shield over the PCMCIA card and card slot.
The printer is now ready to operate with the additional memory or font option.
Figure 26 • Installing the PCMCIA Card
Caution • Observe proper electrostatic safety precautions when handling any
static-sensitive components such as circuit boards and printheads.
static-sensitive components such as circuit boards and printheads.
Note • The PCMCIA card is hot-swappable. It can be installed while the printer is On (l).
Note • Initialization of the PCMCIA card may take a few minutes; the Pause LED flashes
while the card initializes. If the card is already initialized, the Pause LED flashes only once or
twice. To verify that the card has successfully initialized, print a configuration label and
review it to see if the new memory card information is listed.
while the card initializes. If the card is already initialized, the Pause LED flashes only once or
twice. To verify that the card has successfully initialized, print a configuration label and
review it to see if the new memory card information is listed.
Card Eject
Button
Notch
PCMCIA
Card
F
u
s
e
F
u
s
e