ZyXEL Communications Corporation 5VZ-A2011 사용자 설명서

Appendix G Legal Information

CellPipe 7130 RG User’s Guide

• This transmitter must not be co-located or operating in conjunction with any 

other antenna or transmitter. 

• IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-

limited to channels 1 through 11. 

• To comply with FCC RF exposure compliance requirements, a separation 

distance of at least 20 cm must be maintained between the antenna of this 

device and all persons. 

This device complies with RSS-210 of the Industry Canada Rules. Operation is 
subject to the following two conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause 
undesired operation of the device

This device has been designed to operate with an antenna having a maximum 
gain of 2dBi.

Antenna having a higher gain is strictly prohibited per regulations of Industry 
Canada. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain 
should be so chosen that the EIRP is not more than required for successful 
communication.

Device for the band 5150-5250 MHz is only for indoor usage to reduce potential 
for harmful interference to co-channel mobile satellite systems; users should also 
be cautioned to take note that high-power radars are allocated as primary users 
(meaning they have priority) of the bands 5250-5350 MHz and 5650-5850 MHz 
and these radars could cause interference and/or damage to LE-LAN devices.

This equipment complies with IC radiation exposure limits set forth for an 
uncontrolled environment. End users must follow the specific operating 
instructions for satisfying RF exposure compliance.

注意 !

依據  低功率電波輻射性電機管理辦法