ZyXEL Communications Corporation EMG2926Q10A 사용자 설명서
Chapter 22 Remote Management
EMG2926-Q10A User’s Guide
158
Figure 108
Management > Remote Management > SNMP
The following table describes the labels in this screen.
Table 67
Management > Remote Management > SNMP
LABEL
DESCRIPTION
SNMP Settings
Server Port
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
use the same port number in order to use that service for remote management.
Server Access
Select the interface(s) through which a computer may access the EMG2926-Q10A
using this service.
using this service.
Secured IP
Select All to allow all computes to access the EMG2926-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can
access the EMG2926-Q10A.
access the EMG2926-Q10A.
SNMP Enable
Select this to enable SNMP on the EMG2926-Q10A.
Select this to allow a manager station to manage and monitor the EMG2926-Q10A
through the network via SNMP.
through the network via SNMP.
Get Community
Enter the password for the incoming Get and GetNext requests from the
management station. The default is public and allows all requests.
management station. The default is public and allows all requests.
Set Community
Enter the password for incoming Set requests from the management station. The
default is public and allows all requests.
default is public and allows all requests.
System Location
Specify the geographic location of the EMG2926-Q10A.
System Contact
Enter the name of the person in charge of the EMG2926-Q10A.
Trap Settings