ZyXEL Communications Corporation EMG6765-Q10A 사용자 설명서
Chapter 26 Troubleshooting
EMG6765-Q10A User’s Guide
187
2
Go to Maintenance > Sys OP Mode. Check your System Operation Mode setting.
• If the EMG6765-Q10A is in Router Mode, make sure the WAN port is connected to a broadband
modem or router with Internet access. Your computer and the EMG6765-Q10A should be in the
same subnet.
same subnet.
• If the EMG6765-Q10A is in Access Point Mode, make sure the WAN port is connected to a
broadband modem or router with Internet access and your computer is set to obtain an dynamic
IP address.
3
If the EMG6765-Q10A is in Router Mode, make sure you entered your ISP account information correctly in
the wizard or the WAN screen. These fields are case-sensitive, so make sure [Caps Lock] is not on.
the wizard or the WAN screen. These fields are case-sensitive, so make sure [Caps Lock] is not on.
4
If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless client are
the same as the settings in the AP.
the same as the settings in the AP.
5
Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
6
If the problem continues, contact your ISP.
I cannot access the Internet anymore. I had access to the Internet (with the EMG6765-Q10A), but
my Internet connection is not available anymore.
1
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide and
Start Guide and
2
Reboot the EMG6765-Q10A.
3
If the problem continues, contact your ISP.
The Internet connection is slow or intermittent.
1
. If the
EMG6765-Q10A is sending or receiving a lot of information, try closing some programs that use the
Internet, especially peer-to-peer applications.
Internet, especially peer-to-peer applications.
2
Check the signal strength. If the signal strength is low, try moving the EMG6765-Q10A closer to the AP if
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
3
Reboot the EMG6765-Q10A.
4
If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
suggestions.
Advanced Suggestion
• Check the settings for QoS. If it is disabled, you might consider activating it.