Garmin International Inc 01675 사용자 설명서

GDL

40 Installation Instructions

February 2011

190-01243-02 Rev. B

Printed in Taiwan

GDL 40–0110233910

About the GDL 40

The GDL 40 antenna provides GSM weather

data to compatible Garmin chartplotters on

your NMEA 2000 network. The GDL 40

communicates with nearby cellular towers

to receive weather data, purchased directly

from a Garmin chartplotter on a day-to-day

basis, as needed.

Contacting Garmin Product

Support

Contact Garmin Product Support if you have

any questions about this product.
• Go to

www.garmin.com/support

• Call (913) 397.8200 or (800) 800.1020.

Registering and Activating

the GDL 40

Before installing the GDL 40 on your

boat, you must activate it online. During

the activation process, you must provide a

credit card that will be charged each time

you purchase a day-pass directly from the

chartplotter.
1. Record the unit ID and the serial number

(S/N) from your GDL 40 below.
The numbers are located on a sticker on

the antenna, and on the outside of the

package.

Unit ID

S/N

2. Go to

http://my.garmin.com.

3. Complete an action:

• Sign in to your myGarmin account.
• If you do not have an existing

myGarmin account, create an

account.

4. Click the link to register your product.
5. Follow the on-screen instructions.

After you successfully register and

activate the antenna, you then purchase

a day-pass directly from the chartplotter

as needed.

Installing the GDL 40



CAUtIoN

Always wear safety goggles, ear protection,

and a dust mask when drilling, cutting, or

sanding. When drilling or cutting, always

check what is on the opposite side of the

surface.

Parts Included

Before installing your device, confirm

that your package includes the following

items. If any parts are missing, contact your

Garmin dealer immediately.
•  GDL 40 antenna
•  Surface-mount bracket
•  Pole-mount bracket
•  Under-deck-mount bracket
•  Three M4 self-tapping screws
•  M3 set screw
•  NMEA 2000 T-connector
•  NMEA 2000 drop cable
•  Installation instructions, surface-mount

template, and registration sheet.

tools Needed

• Drill and drill bits
• Countersink bit—when mounting on

fiberglass

• Jigsaw—surface-mount hole
• Screwdriver—surface mount screws

optional Equipment

• Marine sealant
• M4 self-tapping screws, shorter than 1 in.

(25 mm)—dependent on the thickness of

the surface in some under-deck-mounting

situations (

page 4

)