Davis Instruments DWW765Y 사용자 설명서
12
The transmitter ID for the station set on the repeater should display on this screen,
with the number displaying above the ticker tape and an “X” displaying on the bottom
right of the console screen. If the transmitter ID is not displayed in this screen, see
“Maintenance and Troubleshooting” on page 25.
with the number displaying above the ticker tape and an “X” displaying on the bottom
right of the console screen. If the transmitter ID is not displayed in this screen, see
“Maintenance and Troubleshooting” on page 25.
2. Press DONE to display Screen 2: Configuring Transmitter IDs.
3. Find the transmitter ID transmitting through the repeater using the right (<)and left (>)
arrows, and if the station is not already toggled on with it’s station type selected, do so
now by pressing the up (+) arrow until “ON” displays on the screen. Change the sta-
tion type by pressing GRAPH until the correct station type displays.
now by pressing the up (+) arrow until “ON” displays on the screen. Change the sta-
tion type by pressing GRAPH until the correct station type displays.
4. Press WIND to turn the repeater function on and to display a repeater ID. Pressing
WIND programs the console to receive the signal from a repeater instead of directly
from a station. The first repeater ID displayed is repeater A and it should be the
selected repeater ID for a single repeater installation.
from a station. The first repeater ID displayed is repeater A and it should be the
selected repeater ID for a single repeater installation.
Note:
Pressing WIND repeatedly cycles through all eight repeater IDs possible and then displays no iID in
the right hand corner. When no repeater ID is shown, the console is configured to listen directly to a
station and not to a repeater.
the right hand corner. When no repeater ID is shown, the console is configured to listen directly to a
station and not to a repeater.
5. Press DONE to continue to the other screens in the Setup Mode, or press and hold
DONE to return to the Current Weather Mode.
Note:
See the Vantage Pro2 console manual for more information on the screens in the Setup Mode if
necessary.
necessary.
To verify that setup was successful, in the console’s current mode:
1. View the transmitter information displaying at the bottom of the console screen.
If the transmitter ID being repeated is displayed and an “X” displays in the bottom
right-hand corner of the ticker tape, the transmitter is being repeated and received by
the console successfully.
right-hand corner of the ticker tape, the transmitter is being repeated and received by
the console successfully.
Choosing a Location
After wireless communication between the station, wireless transmitter and console has
all been tested, choose a location that best suits the wireless communication needs of all
three units. Choosing a location for the wireless repeater should be based on the follow-
ing requirements:
all been tested, choose a location that best suits the wireless communication needs of all
three units. Choosing a location for the wireless repeater should be based on the follow-
ing requirements:
1