GIGA-BYTE TECHNOLOGY CO. LTD. GN-AP01G 사용자 설명서

다운로드
페이지 67
GN-A11G Wireless LAN Access Point 
i
 
Federal Communication Commission Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules.   These limits are designed to provide reasonable protection against harmful 
interference in a residential installation.    This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications.  However, there is no guarantee that interference will not occur in a particular 
installation.    If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference 
by one of the following measures: 
 
-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
-  Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate this equipment. 
 
IMPORTANT NOTE: 
 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 
equipment should be installed and operated with minimum distance 20cm between the radiator & your 
body. 
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 
 
GIGABYTE declares that GN-AP01G (FCC ID: JCK-GN-AP01G) is limited in CH1~CH11 for 2.4GHz by 
specified firmware controlled in U.S.A.