GIGA-BYTE TECHNOLOGY CO. LTD. GN-WI01GT 사용자 설명서
FCC Statements:
1. This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna
and users. For laptop installations, the antenna must be installed to ensure that the
proper spacing is maintained in the event the users places the device in their lap
during use (i.e. positioning of antennas must be placed in the upper portion of the
LCD panel only to ensure 20 cm will be maintained if the user places the device
in their lap for use), and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter test will not b required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed
(for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
1) The antenna must be installed such that 20 cm is maintained between the antenna
and users. For laptop installations, the antenna must be installed to ensure that the
proper spacing is maintained in the event the users places the device in their lap
during use (i.e. positioning of antennas must be placed in the upper portion of the
LCD panel only to ensure 20 cm will be maintained if the user places the device
in their lap for use), and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter test will not b required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed
(for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may
be installed such that 20 cm may be maintained between the antenna and users
(for example access points, routers, wireless ADSL modems, certain laptop
configurations, and similar equipment). The final end product must be labeled in a
visible area with the following: "Contains TX FCC ID: JCK-GN-WI01GT".
Manual Information for End Users
The end user must not have manual instructions to remove or install the device.
The user manual for end users must include the following informatio in a prominent
location:"IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter."
be installed such that 20 cm may be maintained between the antenna and users
(for example access points, routers, wireless ADSL modems, certain laptop
configurations, and similar equipment). The final end product must be labeled in a
visible area with the following: "Contains TX FCC ID: JCK-GN-WI01GT".
Manual Information for End Users
The end user must not have manual instructions to remove or install the device.
The user manual for end users must include the following informatio in a prominent
location:"IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter."