GIGA-BYTE TECHNOLOGY CO. LTD. GN-WI01HT 사용자 설명서

 

1)  The antenna must be installed such that 20 cm is maintained between the antenna and users, 

and   

2)The antenna should use a unique coupling to ensure that no antenna other than that funished by 

the responsible party shall be used with the device. 

As long as 2 conditions above are met, further transmitter test will not be required. However, the 

OEM integrator is still responsible for testing their end-product for any additional compliance 

requirements required with this module installed (for example, digital device emissions, PC 

peripheral requirements, etc.). 

IMPORTANT NOTE: 

In the event that these conditions can not be met (for example certain 

laptop configurations or co-location with another transmitter), then the FCC authorization is no 

longer considered valid and the FCC ID can not be used on the final product. In these 

circumstances, the OEM integrator will be responsible for re-evaluating the end product (including 

the transmitter) and obtaining a separate FCC authorization. 

This transmitter module is authorized only for use in device where the antenna may be installed 

such that 20 cm may be maintained between the antenna and users (for example : Wireless 

Router. Access point… etc.). The final end product must be labeled in a visible area with the 

following: “Contains TX FCC ID: JCK-GN-WI01HT”. 

The OEM integrator has to be aware not to provide information to the end user regarding how to 

install or remove this RF module in the users manual of the end product which integrate this 

module. 

The users manual for OEM integrators end users must include the following information in a 

prominent location “ IMPORTANT NOTE: To comply with FCC RF exposure compliance 

requirements, the antenna used for this transmitter must be installed to provide a separation 

distance of at least 20 cm from all persons and must not be co-located or operating in conjunction 

with any other antenna or transmitter”.  

If the end product integrating this module is going to be operated in 5.15 ~ 5.25GHz frequency 

range, the warning statement in the user manual of the end product should include the following 

 "Within 5.15-5.25GHz band, U-NII devices will be restricted to indoor operations to reduce any 

 potential for harmful interterence to co-channel MSS operations. Usage of this device outdoor could

 void the user’s authority to operate the equipment." 

 

GIGABYTE  declares that  GN-WI01HT ( FCC ID: JCK-GN-WI01HT) is limited in CH1~CH11 for 

2.4GHz by specified firmware controlled in U.S.A.