GIGA-BYTE TECHNOLOGY CO. LTD. GN-WPKG 사용자 설명서
14
3-1-2. Authentication & Security setting:
Authentication & Security: One of the settings in the Profile Page; this settings includes
Authentication type selection, Encryption key input type & length of the
encrypted/decrypted payload information, and WEP key index selection. (see Figure 3-4)
Authentication type selection, Encryption key input type & length of the
encrypted/decrypted payload information, and WEP key index selection. (see Figure 3-4)
Figure 3-4.
Authentication & Security
Configuration
This card provides Three security options: No security, WEP encryption, WPA-PSK
security architecture.
3-1-2-1. No security (None):
Allows the communication between the WLAN card and access point without data
encryption.
3-1-2-2. Use WEP for authentication and encryption:
To prevent unauthorized user to access the data on wireless stations, the WLAN Card
offers a secure data encryption, known as WEP (Wired Equivalent Privacy). When you
select this item, the target 802.11 device must has the same encryption keys and be
configured to use encryption in order to communicate with each other. To configure your
WEP encryption, please click “Encryption Type “then the following window will pop up
(see Figure 3-4).
To configure your encryption key, please follow these steps:
1. Select a Key Entry Method (Hexadecimal or ASCII).
2. Enter one unique encryption key and its key length.
3. Enter one to four different shared keys and their individual key length.
For 64-bit encryption, enter 10 digitals by Hex or 5 characters by ASCII.
For 128-bit encryption, enter 26 digitals by Hex or 13 characters by ASCII.
4. Select only a key to encrypt your transmission data.
5. Click “OK” to save these settings.
security architecture.
3-1-2-1. No security (None):
Allows the communication between the WLAN card and access point without data
encryption.
3-1-2-2. Use WEP for authentication and encryption:
To prevent unauthorized user to access the data on wireless stations, the WLAN Card
offers a secure data encryption, known as WEP (Wired Equivalent Privacy). When you
select this item, the target 802.11 device must has the same encryption keys and be
configured to use encryption in order to communicate with each other. To configure your
WEP encryption, please click “Encryption Type “then the following window will pop up
(see Figure 3-4).
To configure your encryption key, please follow these steps:
1. Select a Key Entry Method (Hexadecimal or ASCII).
2. Enter one unique encryption key and its key length.
3. Enter one to four different shared keys and their individual key length.
For 64-bit encryption, enter 10 digitals by Hex or 5 characters by ASCII.
For 128-bit encryption, enter 26 digitals by Hex or 13 characters by ASCII.
4. Select only a key to encrypt your transmission data.
5. Click “OK” to save these settings.