HID Global Corporation 5553 사용자 설명서
HF Multi ISO RFID Reader User Manual, Firmware V1.4
1508-USM-00-0-04
3
EMVCO Commands
For EMVCO processing details, reference the
EMV Contactless Communication Protocol Specification
.
Command
Description
Response
Description
1.Card Number
Single PICC found
2.’C’
Collision detected
‘_p’ ( Poll Command)
No Data
No Data
This command enters EMV
mode and starts polling. The
reader scans for the field for
ISO 14443 A and B cards
until card is found.
mode and starts polling. The
reader scans for the field for
ISO 14443 A and B cards
until card is found.
3.’N’
Timeout error
1. 0x01
Polling for PICC
2. 0x02
Activating PICC
3. 0x03
Transaction mode.
‘_s’ ( Status Command)
No Data
No Data
Gets the reader state in
EMVCO mode.
EMVCO mode.
4. 0x04
Removal procedure of PICC
1. Card response
2. ‘N’
Timeout error
3. ‘P’
Protocol error
4.’F’ Transmission
error(CRC/BCC)
‘_tt’ (Transfer command
)
Data – APDU(n Bytes)
)
Data – APDU(n Bytes)
This command starts a half
duplex block transmission
sequence with an already
activated tag.
duplex block transmission
sequence with an already
activated tag.
5. ‘O’
FIFO Overflow error
‘_r’ ( Remove Command)
No Data
No Data
This command starts the
removal procedure of PICC.
removal procedure of PICC.
‘N’
Timeout error after the removal
is completed.
is completed.
‘_q’ ( Quit Command)
This command quits the
reader form the EMV mode
reader form the EMV mode
‘Q’
Quit from EMV mode
No data
Unknown command
‘?’
August 2010
Page 103 of 144
© 2005-2010 HID Global Corporation. All rights reserved.