Trimble Inc. 59646 사용자 설명서

The Trimble WinFlash software is a Microsoft Windows-based application that 
configures the AQUA for use in a network. Use WinFlash to configure all AQUA radios 
required for a project. 
 
To configure a AQUA using WinFlash, complete the following procedures: 
•  Connect the office computer to the AQUA. 
•  Configure the AQUA using WinFlash. 
 
These procedures are discussed in the following sections. 

1.  Connect a radio service cable to the AQUA. 
2.  Connect the I/O DB-9 connector of the service cable to a serial port on your office 

computer. 

 
Note – Figure 4.7 on page 27 shows an infrastructure cable (PN 38968-25) connected 
to the AQUA. Figure 4.10 on page 30 shows the service cable (PN 40942-xx) 
connected to the AQUA and an office computer. 
3.  Provide power to the radio through the power lead of the service cable. 

The following general steps are used to configure an Aqua radio.  See the specific radio 
section for information on radio configurations. 

1.  Start WinFlash on your office computer. The following dialog appears: 
 
2.  Select the appropriate Device type option and PC serial port option and click 

Next.  

 

3.  Select the Configure radio option in the Operations group and click Next. 
 
4.  Click Finish on the next screen to establish a connection with the radio. The 

following dialog appears while WinFlash is connecting to the radio:  

 
5.  When WinFlash has successfully connected to the radio, the Properties window 

appears: 

 
6.  From the Properties window, configure radio. Once these settings are correct, 

click Set to send the settings to the radio.  

 
7.  To finish, click Exit. To make further changes, click Menu. The Operation 

Selection dialog shown in Step 2 on page 11 appears. The following sections 
describe the settings that are available for the AQUA.