Sam Joo Electronic Co SJ80A 사용자 설명서
Instruction # 3: LED Status Indicator
TRIGGER DESCRIPTION
LED OUTPUT
N/A Armed
Steady
Flash
N/A
Valet Mode
Constantly On
1
Impact Sensor
2 Flashes then Pause
2
(-) Door Trigger
3 Flashes then Pause
3
(+) Door Trigger
3 Flashes then Pause
4
Current Sensing(Trunk)
4 Flashes then Pause
5
Ignition “On”
5 Flashes then Pause
6
(-)External Trigger In
6 Flashes then Pause
Instruction #4: Emergency Disarm
(If you lost a remote and
can not shut off the alarm)
1. With your vehicle key in the key cylinder, turn it on. (On means driving
position)
2. Have your door open
3. Turn the ignition switch On/Off 4 Times.
1. With your vehicle key in the key cylinder, turn it on. (On means driving
position)
2. Have your door open
3. Turn the ignition switch On/Off 4 Times.
Instruction #5: Personal Protection Alarm (PANIC)
1. Press and hold Button#1 for approximately for three seconds.
2. Personal Panic alarm is activated and siren sounds and lights flash for
30 seconds.
3. Press and release the transmitter button #1 to cancel the panic mode.
Press & hold
button #1 for 3 SEC.
button #1 for 3 SEC.
Light
flashes
flashes
Siren(30Sec)
Instruction # 6: CH2 Trunk Release
(OPTIONAL)
1. Press and hold down the transmitter #2 until trunk release.
2. You want to disarm the system when CH-2 is used. However, alarm
stay in previous mode (Arm or Disarm).
Page–2