Silverstone ST85ZF SST-ST85ZF 사용자 설명서
제품 코드
SST-ST85ZF
Description:
Electrical Specification
SilverStone Technology Co., Ltd.
Subject:
SilverStone Technology
Model: ST85ZF
Switching Power Supply
Document No.:
ES-850-ZEUS-01
File Name: ST85ZF.doc Page : 3
2.10 Radiated Immunity, IEC61000-4-3
Frequency
Electric Field Strength
27 MHz to 500 MHz, un-modulated
3 V/m
3. DC Output Specification
3.1 Output Current / Loading
The following tables define two power and current rating. The power supply shall meet both static and
dynamic voltage regulation requirements for minimum load condition.
dynamic voltage regulation requirements for minimum load condition.
Output
Voltage
+5V +3.3V
+12V1
+12V2 +12V3 +12V4
-12V +5VSB
Max.
Load
30A 24A 18A 18A 18A 18A 0.5A 3A
Min.
Load
1.0A 1.5A 0.8A 0.8A 0.5A 0.5A 0A 0.1A
Table 5 – Output Loads Range 1:
Note 1: The +5 & +3.3 Volt total output shall not exceed 180 W.
Note 2: Maximum continuous total DC output power should not exceed 850 W.
Note 2: Maximum continuous total DC output power should not exceed 850 W.
Note 3: Maximum continuous load on the combined 12 V output shall not exceed 70 A.
3.2 DC Voltage Regulation, Ripple and Noise
The power supply output voltages must stay within the following voltage limits when operating at steady state
and dynamic loading conditions. All outputs are measured with reference to the return remote sense (ReturnS)
signal. The +5V,+3.3V, +12V, -12V and +5VSB outputs are measure at the power supply connectors
references to ReturnS. The +5V and +3.3V is measured at its remote sense signal (+5VS+, +3.3VS+) located
at the signal connector.
and dynamic loading conditions. All outputs are measured with reference to the return remote sense (ReturnS)
signal. The +5V,+3.3V, +12V, -12V and +5VSB outputs are measure at the power supply connectors
references to ReturnS. The +5V and +3.3V is measured at its remote sense signal (+5VS+, +3.3VS+) located
at the signal connector.
Output
Voltage
+5V +3.3V
+12V1
+12V2
+12V3
+12V4 -12V +5VSB
Load
Reg. +/-5% +/-5%
+/-5%
+/-5%
+/-5%
+/-5% +/-10% +/-5%
Line Reg.
±1%
±1%
±1%
±1%
±1%
±1%
±1% ±1%
Ripple & Noise 50mV
50mV
120mV 120mV 120mV 120mV
120mV 50mV
Table 7 – Regulation, ripple and noise