Yaesu Musen Co. Ltd. 20251X50 사용자 설명서

 

FT-2000 

Operating Manual 

Vertex Standard Co., Ltd. 

74

Advice: 

 

To listen to the pile-up calling the DX station, so as to find the station currently 

being worked, you may press the [RX CLAR] button. Once you have zeroed in on 
the station calling the DX (use the SPOT function on CW for precise alignment of 
your frequency), you may then press the [RX CLAR] button again to cancel the RX 
Clarifier, and return to reception on the DX station’s frequency. 

 

Just as with receiver Clarifier operation, the amount of offset from the original 

VFO frequency will appear in the small display window. 

 

As with receiver Clarifier operation, when you turn the TX Clarifier off the 

last-used offset is not lost, and will be available if you turn the TX Clarifier back on. 
To clear the Clarifier offset, press the [CLEAR] button. 

 
Clarifier Offset Bar Indicator 
A visual depiction of the relative offset of the Clarifier may be displayed, using the Bar 
Indicator. 
1.  Press the [MENU] button; the Menu list will appear in the display. 
2.  Rotate the Main Tuning Dial knob to select Menu item “010 diSP BAR SEL.” 
3.  Rotate the [SUB VFO-B] knob to select “CLAr” form the available choices; the 

factory default is “C-tn.” 

4.  Press and hold in the [MENU] button for two seconds to save the new setting and 

exit to normal operation. 

 
Split-Frequency Operation 
A powerful capability of the FT-2000 is its flexibility in Split Frequency operation, 
using the Main (VFO-A) and Sub (VFO-B) frequency registers. This makes the FT-2000 
especially useful for high-level DX-pedition use, as the Split operation capability is very 
advanced and easy to use. 
 
1.  Set the Main (VFO-A) frequency as desired. 
2.  Set the Sub (VFO-B) frequency. 
3.  Now press the [SPLIT] button. The front panel switch/LEDs will look like this: 

Main (VFO-A) 

[RX] switch “ON” (LED glows Green) 
[TX] switch “OFF” (LED Off) 

Sub (VFO-B) 

[RX] switch “OFF” (LED Off)