Yaesu Musen Co. Ltd. 20251X50 사용자 설명서
FT-2000
Operating Manual
Vertex Standard Co., Ltd.
97
blink in the multi-panel window.
While operating in the VFO mode, using Memory Check, you may store the
current contents of the Main (VFO-A) resistor into the selected memory by pressing
and holding in the [A>M] button for two seconds (until the double beep). Conversely,
if you wish to write the contents of the current memory into the Main (VFO-A)
register, press and hold in the [M>A] button for two seconds.
and holding in the [A>M] button for two seconds (until the double beep). Conversely,
if you wish to write the contents of the current memory into the Main (VFO-A)
register, press and hold in the [M>A] button for two seconds.
Erasing Memory Channel Data
1. Press the [A>M] button.
The data stored in the currently-selected memory channel will be displayed in the
Sub (VFO-B) band frequency field.
Sub (VFO-B) band frequency field.
2. Rotate the [SUB VFO-B] knob to select the memory channel that you would like to
erase.
3. Press the [LOCK] button to erase the contents of the selected memory channel.
Advice:
Advice:
After erasure, only the memory channel number will remain; the frequency data
will disappear from the display.
If you make a mistake and wish to restore the memory’s contents, just repeat steps
(1) through (3) above.
Moving Memory Data to the Main Band (VFO-A)
You may transfer the contents of the currently-selected memory channel into the Main
band (VFO-A) register, if you like.
1. Press the [V/M] button, as necessary, to go to the Memory mode. The memory
channel number will appear in the multi-panel window.
2. Press the [M CH] button. The Red LED inside the switch will light up, indicating
that you are ready to recall a memory channel.
Advice: If the Red LED imbedded in the [M CH] button does not light up, check to
be sure that the orange lamp to the right of the [SUB VFO-B] knob is not
illuminated. If it is, press the [A/B] switch to make it go out, then press the [M CH]
button again.
Advice: If the Red LED imbedded in the [M CH] button does not light up, check to
be sure that the orange lamp to the right of the [SUB VFO-B] knob is not
illuminated. If it is, press the [A/B] switch to make it go out, then press the [M CH]
button again.
3. Rotate the [SUB VFO-B] knob to select the memory channel the contents of which
you wish to transfer to the Main band (VFO-A).