Radicom Research Inc RW8200 사용자 설명서
Important features:
1. Antenna types
The RW8200 can have either an ON Board Chip antennae or an U.FL connector for
external antennae connections.
2. Serial Port
The RW8200 supports serial port and can set baud rate from 1200 up to 921600 bps. The
default speed is 115200bps with one start, 1stop and no parity bit. When power on, if pin
20 signal is pulled low, the default speed is 115200bps.
3. Command/data mode
To exit from data mode, you can issue an Escape sequence (+++) or use pin 20 of RW8200
module and RW8200-HM.
4. Flow control
No flow control is needed for Network protocol. The BPM8200 does not have flow control
at all.
1. Antenna types
The RW8200 can have either an ON Board Chip antennae or an U.FL connector for
external antennae connections.
2. Serial Port
The RW8200 supports serial port and can set baud rate from 1200 up to 921600 bps. The
default speed is 115200bps with one start, 1stop and no parity bit. When power on, if pin
20 signal is pulled low, the default speed is 115200bps.
3. Command/data mode
To exit from data mode, you can issue an Escape sequence (+++) or use pin 20 of RW8200
module and RW8200-HM.
4. Flow control
No flow control is needed for Network protocol. The BPM8200 does not have flow control
at all.
RW8200 COMMAND SET
Command
Parameter
Descriptions
? 0,
“Help
menu”
help 0,
“Help
menu”
ping, 0,
“<destination>”
“Pings the specified IP or Host.”
“Pings the specified IP or Host.”
get_random,
0,
“Get a random number.”
get_mac_addr,
0,
“Get the device MAC address.”
get_rssi, 0,
“Get the received signal strength of
the AP (client mode only).”
the AP (client mode only).”
tcp_server,
0,
“Turn on TCP Server mode.”
tcp_client,
1,
“Turn on TCP Client mode.”
join, 2,
“<ssid><open|wpa|wpa2>[key][ip netmask
gateway]”
“Join an AP. DHCP assumed if no IP
address provided”
gateway]”
“Join an AP. DHCP assumed if no IP
address provided”
join, 4,
“<ssid><open|wpa|wpa2><key>[ip netmask
gateway]”
“Join a specific AP. DHCP assumed if no
IP address provided.”
gateway]”
“Join a specific AP. DHCP assumed if no
IP address provided.”
leave,
0,
“Leave an AP.”
powersave,
1,
“Enable/disable power save mode.”
scan, 0,
“Scan all enabled channels and print a
list of APs found.”
list of APs found.”
set_ip,
3,
“Set a static IP.”
set_tx_power,
1,
“Set the tx power in dBm.”
get_tx_power,
0,
“Gets the tx power in dBm.”
status,
0,
“Print status of the WiFi and network
25