Matrix Systems Inc 0114405 사용자 설명서

 

3

 
The Reader Control Module,  model number 04-14000 is designed to interface with the Matrix 
family of card readers.  These include the magnetic stripe card readers: MX1, MX2,   
and 01-14440 / 14441.  
 
The RCM2 will also interface to the proximity family of card readers:  MX1-Prox,  MX2-Prox,   
 and the MX- iCLASS. 
 
The RCM2 provides access control and alarm point monitoring for up to two separate portals, 
providing entry and exit reader monitoring at each portal. 
 
 
WIRING CONSIDERATIONS 
 
Wiring between devices must be installed in a professional manner using any applicable local and 
national codes and using the following suggestions 
 

•  For hollow wall construction, use ¾” electrical conduit or flexible metallic conduit. 

Minimally, the conduit should be extended from the reader location to above the ceiling. 

•  For solid or hard surface construction, use ¾” electrical conduit or equally-sized metallic wire-

mold. Plastic wire-way should not be used. 

 

When wiring the RCM2 to the host system and portal devices, care should be taken in using the 
appropriate cable. Matrix Systems provides custom cable with either a PVC jacket, part number  
53-12009, or a plenum-rated Teflon jacket, part number 53-12010, as shown in the figure below. 

22 AWG wire with shield and drain wire. 

Used for communications lines. 

 
 
 
 
          Green / White used for lock power. 
 

18 AWG wire 

          Red / Black used for RCM / Reader power.