CALAMP WIRELESS NETWORKS INC. 1409290100 사용자 설명서

3.3

Required Tools and Materials

In order to install the Pico Base, a standard professional toolbox is required.

3.4

Installing the Pico Base

Note: Should be installed at highest possible point!

Important!

The equipment should be installed in compliance with the National Electrical Code (NEC),

ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part 1, CSA C22.1; and when applicable, the

National Electrical Safety Code IEEE C2. Unless marked or otherwise identified, the Standard for

the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

There are two types of installations for the Pico Base:

Wall mount - The Pico Base can be attached to any wall that can support the load of the

unit.

Pole mount - The unit can be attached to any pipe or pole with diameter 1.75” to 10".

3.4.1

Overview

The Pico Base installation procedure consists of the following steps:

1. Covering the Console port (only used for maintenance purposes by authorized personnel) –

2. Assembling the PoE connector – see 3.4.3.

3. Assembling the Pico Base mounting bracket – see 3.4.4.

4. Mounting the Pico Base (wall/pole mount) – See 3.4.5.

5. Antenna connections and grounding – see 3.4.6.

6. Connecting the Pico Base Data Adapter – see 3.4.7.

7. See chapter 4 for the initial Setup procedure.