Acumen Technologies Ltd 502 사용자 설명서
Page 1 of 3
Acumen Model J
Fireplace Remote Control Operating Instructions For The Homeowner
The Acumen Model J Remote Control is designed for use with decorative gas fireplace and wall
heaters using a Millivolt gas valve.
BEFORE YOU BEGIN:
INSTALLING FRESH BATTERIES:
Note: It is not necessary to re-set your private code when Installing Fresh Batteries.
The fireplace MUST be OFF before replacing transmitter batteries.
INSTALL BATTERIES INTO RECEIVER:
INSTALL BATTERIES INTO TRANSMITTER:
Press and then Release
Change Batteries At Least Every 6 Months:
WARNING:
THE REMOTE TRANSMITTER WILL AUTOMATICALLY SWITCH OFF THE
FIREPLACE WHEN THE BATTERIES IN THE REMOTE TRANSMITTER ARE LOW.
The pilot flame must be lit, with the gas control valve turned to "ON", for the
remote to work correctly.
Read all of the safety precautions in the owner's manual included with your
fireplace before using this remote control.The thermostat is not
intended for
unattended use.
Warning:
Fresh Alkaline
AA Batteries.
PRESS
TO OPEN
PRESS
TO OPEN
FIREPLACE REMOTE
PRESS
TO OPEN
OFF
ON
REMOTE
BAT.LOW
RECEIVER OPERATION:
Fireplace Controlled
by Remote
Fireplace Off
Fireplace On
Low Battery
Indicator
OFF REMOTE ON
BAT.LOW
PRESS TO OPEN
OFF REMOTE ON
BAT.LOW
PRESS TO OPEN
OFF REMOTE ON
BAT.LOW
PRESS TO OPEN