Digital Security Controls Ltd. 02RF5501433 사용자 설명서

2

The RF5501-433 package includes the following par

The RF5501-433 package includes the following par

The RF5501-433 package includes the following par

The RF5501-433 package includes the following par

The RF5501-433 package includes the following parts:

ts:

ts:

ts:

ts:

• One RF5501-433 keypad
• One 5.6K Ohm resistor

• Four mounting screws

• One keypad inner door label

• One set of Fire, Auxiliary and Panic key labels

• One LCD5501Z User Sheet

• One RF5501-433 Installation Manual

You should mount the keypad where it is accessible to designated points of entry
and exit. Once you have selected a dry and secure location, perform the following
steps to mount the keypad:

1. Remove the keypad backplate by loosening the screw located at the base of the

unit.

2. Secure the keypad backplate to the wall in the desired location. Use the screws

provided.

3. Before attaching the keypad to its backplate, complete the keypad wiring as

described in the next section.

1. Before beginning to wire the unit, ensure that all power (AC transformer and battery)

is disconnected from the control panel.

2. Connect the four Keybus wires from the control panel (red, black, yellow, green, P1

and P2/Z) to the keypad terminals (R B Y G P1 P2/Z). Consult the diagram below:

RF5501-433

Red Blk Yel Grn P1 P2/Z

3. You can connect a device, such as a door contact, to the “Z” terminal of the RF5501-

433. This eliminates the need to run wires back to the control panel for the device. To
connect the zone, run one wire from the device to the Z terminal and the other wire from
the device to the B (black) terminal. For powered devices, run the red wire to the R
(positive) terminal and the black wire to the B (negative) terminal. When using end of
line supervision, connect the zone according to one of the configurations outlined in
your system’s 

Installation Manual.

Installation

NOTE:  P

2

 

 is  also the zone input

terminal when programmed (see
section [90].