Digital Security Controls Ltd. 09GS260L 사용자 설명서
25
NOTE: *Receivers 1 and 3 can be supervised; if enabled, heartbeats are sent.
Receivers 2 and 4 cannot be super-
vised.
Programming Options
Option 011: Installer Code
Default (CAFE)
This option is used to program the installer code of the Communicator module. Valid entries range from 0000 to FFFF hexadeci-
mal.
mal.
Option 012: DLS Port
Default (3062)
The DLS Port is the port DLSV will use when connecting to the Communicator. Valid entries range from 0000 to FFFF hexadeci-
mal.
mal.
Option 013: DLS Local Port
Default (3063)
The DLS local port is used when the Communicator is connecting to DLSV. You can use this option to set the value of the local
outgoing port. Set the value of this port if your installation is located behind a firewall and must be assigned a particular port num-
ber, as determined by your network administrator. Valid entries range from 0000 to FFFF hexadecimal.
outgoing port. Set the value of this port if your installation is located behind a firewall and must be assigned a particular port num-
ber, as determined by your network administrator. Valid entries range from 0000 to FFFF hexadecimal.
Ethernet Receiver 1 Options
Option 101: Ethernet Receiver 1 Account Code
Default (0000FFFFFF)
The account code is used by the central station to distinguish between transmitters. This account code is used when transmitting
signals to the central station receiver. Signals received from the control panel will use the control panel account number. Valid
entries will range from 0000000000 to FFFFFFFFFF hexadecimal.
signals to the central station receiver. Signals received from the control panel will use the control panel account number. Valid
entries will range from 0000000000 to FFFFFFFFFF hexadecimal.
Option 102: Ethernet Receiver 1 DNIS
Default (000000)
The DNIS is used in addition to the Account Code to to identify the Communicator module as the central station. Valid entries
range from 000000 to 0FFFFF hexadecimal.
range from 000000 to 0FFFFF hexadecimal.
Option 103: Ethernet Receiver 1 Address
Default (0.0.0.0)
Enter the Ethernet receiver 1 IP address. This information will be provided by your central station. Note that when a valid address
has been entered, the Ethernet will be considered to be enabled and will communicate events over the Ethernet channel. The
has been entered, the Ethernet will be considered to be enabled and will communicate events over the Ethernet channel. The
Bit 8
Reserved
Disabled (Off)
Table 7: System Toggle Options
Valid Data Range
Effect
Default