Fleetwood Group Inc DS6MA 사용자 설명서
15
Battery
Indicator
Indicator
2.2.6. Inter - Student Communication
2.2.6.1. Pairing
Two students who are using Student Transceivers can communicate with each other by connecting a
patch cord between the audio in/out jacks of both Student Transceivers. Both Students can now hear
each other. The lesson channel should be set to the same channel for both Students.
patch cord between the audio in/out jacks of both Student Transceivers. Both Students can now hear
each other. The lesson channel should be set to the same channel for both Students.
2.2.7. Battery Check
Battery Indicator is located in the upper left hand corner of the LCD screen. (see figure 9)
Figure 9
2.2.8. To Change The Battery
See section 3.2.1. - How to change batteries.
2.2.9. To Record/Playback On a Separate Recorder
The students can use a patch cord between their headset “MONITOR JACK” (#6) and a portable
recorder (optional) mic/auxiliary input jack. Place the recorder in record mode by pressing the Play
and Record Buttons. To play the recording back or play lessons individually to each student, plug the
patch cord between each student’s portable recorder’s earphone or speaker out jack and the headset
“MONITOR JACK” (#6). Select an unused but active channel on the student headset “CHANNEL
SELECTOR” (#1) to avoid hearing two lessons.
recorder (optional) mic/auxiliary input jack. Place the recorder in record mode by pressing the Play
and Record Buttons. To play the recording back or play lessons individually to each student, plug the
patch cord between each student’s portable recorder’s earphone or speaker out jack and the headset
“MONITOR JACK” (#6). Select an unused but active channel on the student headset “CHANNEL
SELECTOR” (#1) to avoid hearing two lessons.
3. Troubleshooting
3.1. Digicall Spectrum® Console
3.1.1. Control Panel
3.1.1. Control Panel
3.1.1.1. Control Panel Removal For Service
The Control Panel is located in the center of the console. To remove the Control Panel, please use the
following instructions.
following instructions.
Tools Required:
• Philips screwdriver
1. Turn off power and unplug the power cord from the wall receptacle.