Everspring Industry Co Ltd ED101 사용자 설명서

ED101 

PIR SENSOR LANTERN 

TRANSMITTER

 

ED101

 

 

Top Cover 

 

Glass 

 

TX module 

 

Mounting Bracket 

 

Front Cover 

⑥  PIR (Motion Sensor) 
 

INTRODUCTION

 
Your EVERSPRING PIR SENSOR LANTERN 
TRANSMITTER is a unique indoor or outdoor lighting 
system for your home or business. At night, the built-in 
passive infrared (PIR) motion sensor turns on the 
LANTERN when it detects motion in its coverage area. 
During the day, the built-in photocell sensor saves 
electricity by deactivating the lantern.   
 
This LANTERN TRANSMITTER is compatible with a 
full series of our O-NET products, serving as a 
transmitter. Upon motion being detected, it will 
illuminate for the length of preset interval and send a 
“Start” radio signal to the associated receiver (refer to 
IMPORTANT) simultaneously.  After expiry of preset 
interval, it will emit a “Stop” radio signal to the receiver 
for execution.   
 
Note: Read this entire manual before you start to 

 

SAFETY PRECAUTIONS

 

 

  Do not install when it is raining.

 

  Be sure to switch off power source before 

installing. 

  Make sure that the power wiring comes from 

circuit with an external 16A miniature circuit 
breaker for the short circuit protection or a suitable 
fuse. 

  Keep minimum 0.5m away from the lighted 

objects. 

 

  The unit can be installed only vertically (FIGURE 

1a), not horizontally (FIGURE 1b) as shown in the 
below drawing. 

 

VERTICAL       HORIZONTAL 

FIGURE 1a & 1b 

IMPORTANT 
Some local building codes may require installation of 
this product by a qualified electrician. 
 
Check your local codes as they apply to your 
situation. If the house wiring is of aluminum, consult 
with an electrician about proper wiring methods. 
 
Before proceeding with the installation, TURN OFF 
THE POWER TO THE LIGHTING CIRCUIT AT THE 
CIRCUIT BREAKER OR FUSE BOX TO AVOID 
ELECTRICAL SHOCK.

 

 

CHOOSING A MOUNTING LOCATION

 

 

  For the best results, fix your lantern on a solid 

surface, 1.8~2.4m above the ground. 

  For outdoor installation, a location under eaves is 

preferable. 

  Avoid aiming the motion sensor at pools, heating 

vents, air conditioners or objects which may 
change temperature rapidly. 

  Do not allow sunlight to fall directly on the front of 

unit. 

  Try to avoid pointing the unit at trees or shrubs or 

where the motion of pets may be detected. 

  Prior to mounting, keep in mind that the motion 

sensor is most sensitive to the motion, which is 
across the detection field and less sensitive to the 
motion, which moves directly towards the detector 
(FIGURE 2). 

 

SENSOR                      SENSOR 

LESS SENSITIVE        MORE SENSITIVE 

FIGURE 2 

 

LANTERN ASSEMBLY

 

 

(1) Fit the lantern compartment onto the base. 

(FIGURE 3)