Lotek Wireless Inc SRX600 사용자 설명서
. . . . .
C O D E L O G M O D E
Chapter overview
Guide to the SRX 600 receiver Rev A #10112
Chapter
5 - - Page 43
C
O D E L O G
M
O D E
5
C
H A P T E R
O V E R V I E W
Codelog
mode is initiated by pressing the Codelog key on the keypad. There are
many features that are accessible from codelog mode.
After pressing the Codelog key, there are three menu items: 1)Config, 2)Scan and
3)Master Ftable
3)Master Ftable
. Each of these menu items leads to different settings and features.
This section of the manual addresses each menu item separately.
Note that 1)Config has a lot of features and settings associated with it, therefore it
is broken down into sections that cover each of its menu items separately. These
sub-menu items are: 1)New CFG#, 2)Scan Settings, 3)Freq/CH, 4)Ant/Hydr,
5)Filters
is broken down into sections that cover each of its menu items separately. These
sub-menu items are: 1)New CFG#, 2)Scan Settings, 3)Freq/CH, 4)Ant/Hydr,
5)Filters
and 6)Sensors. This section also follows the structure of the SRX Host
software.
S
E C T I O N
O
V E R V I E W
An outline of the sub-menu items and the settings available through them is as
follows:
follows:
1)New CFG
• Select a Configuration
2)Scan Settings
• Select the appropriate Code Set
• Define the Scan Time and Total Scan Time
• Enable/Disable TOA
• Enable/Disable CRTO
• Enable/Disable AGC
• Enable/Disable GPS Clock