Biolase Inc. EPIC-1 사용자 설명서
EPIC™10 User Manual
pg. 17
5400525 Rev B
4. OPERATION INSTRUCTIONS
4.1 SYSTEM SETUP
• Place the unit in a clean, dry, and well-ventilated area.
• Verify power switch is in the OFF (O) position.
• EPIC will work using either DC power or the rechargeable battery pack:
• Verify power switch is in the OFF (O) position.
• EPIC will work using either DC power or the rechargeable battery pack:
o
DC Power: Connect the power cord of the power supply to the laser console and plug
into a wall outlet
o
Rechargeable Battery: The EPIC is shipped with the battery pack already installed; to
charge the battery pack, connect the power cord of the DC power supply to the laser
console and plug into a wall outlet. Before first use, fully charge the battery (at least 3
hours). Once the battery is charged, unplug the power cord from the wall outlet and
the laser console. The laser console will run on battery power alone.
console and plug into a wall outlet. Before first use, fully charge the battery (at least 3
hours). Once the battery is charged, unplug the power cord from the wall outlet and
the laser console. The laser console will run on battery power alone.
NOTE:
To fully charge the battery, plug the power supply in and then turn the laser console
ON (I) at the Power Switch. The laser console will start to charge and the unit will go
into sleep mode (with the screen off) after 5 minutes; if the power supply is plugged in
but turned OFF (O) at the Power Switch, the battery will still charge, but at a slower
rate.
ON (I) at the Power Switch. The laser console will start to charge and the unit will go
into sleep mode (with the screen off) after 5 minutes; if the power supply is plugged in
but turned OFF (O) at the Power Switch, the battery will still charge, but at a slower
rate.
• Connect the fiber to the laser console (see Section 2).
CAUTION:
Do not connect or disconnect the fiber while the laser console is turned ON.
Only connect or disconnect the fiber when the laser console is turned OFF.
Only connect or disconnect the fiber when the laser console is turned OFF.
CAUTION:
Do not cover or block ventilation channels. These channels provide an air-flow
path to cool the unit.
path to cool the unit.
CAUTION:
Do not bend the fiber optic at a sharp angle, as it is can break. Make sure it is
not caught or pinched between the housing and the fiber optic access plug.
not caught or pinched between the housing and the fiber optic access plug.
• Remove protective cap from the end of the fiber shaft (see Figure 2.4).
• Carefully connect the handpiece to the fiber optic assembly (see Figures 2.4, 2.5).
• Insert the selected tip and tighten it clockwise until snug (see Figure 2.7).
• Wind any excess fiber optic cable onto the fiber spool counterclockwise around the base
• Carefully connect the handpiece to the fiber optic assembly (see Figures 2.4, 2.5).
• Insert the selected tip and tighten it clockwise until snug (see Figure 2.7).
• Wind any excess fiber optic cable onto the fiber spool counterclockwise around the base
of the console.
• The handpiece is now ready to use. To store the handpiece, place it in the handpiece
holder located at the top of the laser console
.